- ページ 9

食器洗い機 AEG FAVORIT 34032のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG FAVORIT 34032 24 ページ。 Aeg dishwasher favorit 34032

• To set the water softener. Refer to the chapter 'Setting the water softener'.

• To deactivate/activate the audible signals. Refer to the section 'Audible signals'.

• To cancel a washing programme in progress. Refer to the chapter 'Setting and starting a

washing programme'.

Delay start button

Use this button to delay the start of the washing programme with an interval of 3 hours.

Refer to 'Select and start a washing programme'.

Programme lights A and B

These lights have also an auxiliary function when you:

• Adjust the level of the water softener.

• Deactivate/activate the audible signals.

The appliance must be in setting mode for these operations:

• To select and start a washing programme.

• To adjust electronically the level of the water softener.

• To deactivate/activate the audible signals.

Press the on/off button. The appliance is in setting mode when:

• All the programme lights are off and the end-of-programme indicator light flashes.

Press the on/off button. The appliance is not in setting mode when:

• Only one programme light comes on.

– It is necessary to cancel the programme to go back to the setting mode. Refer to 'Set-

ting and starting a washing programme'.

You can hear the audible signals when:

• The washing programme ends.

• The appliance has a malfunction.

Do these steps to deactivate the audible signals:

Switch on the appliance.

Make sure that the appliance is in setting mode.

Press and hold the programme button until the programme light A flashes and the

programme light B comes on.

When the programme light A flashes and the programme light B comes on, press im-

mediately the programme button again.

The programme light A comes on and the programme light B starts to flash.

After some seconds the programme light A goes off and the end-of-programme indi-

cator light comes on. (The programme light B continues to flash).

– The audible signals are active.

Press the programme button again. The end-of-programme indicator light goes off.

Control panel