- ページ 3
スポーツ&アウトドア All American Scoreboards 8203のPDF マニュアルをオンラインで閲覧またはダウンロードできます。All American Scoreboards 8203 15 ページ。 Racing scoreboards

The 8000 Console Backplate.
Adapter LED
Orange = Adapter is good.
Red = Adapter supplies
enough power to run, but not
enough to charge the battery.
Radio Controlled Units Only
Setup Instructions:
Press
once to turn on.
Follow prompts on screen.
Press
and hold to turn off.
RJ45
STORING:
Battery should be fully charged when storing, and should be kept at room temperature.
Recharging once every 30 to 45 days of storage is recommended. If batteries are stored
longer, it may take two or three cycles before full run time is restored.
AC Adapter
Plug the
supplied 12VDC
adapter into a
standard
115VAC outlet.
RJ45
RJ45
RJ45
Scoreboards
For hard-wired models only, plug the scoreboard(s) into the console using
an RJ45 connector. Plug in all hard-wired scoreboards, shot clocks, delay of
game timers, segment timers and stat panels here.
Security Key | Auxiliary I/O
Used to connect consoles together for use with stat panels, etc.
Timer Controllers
Plug in seperate All American consoles that control shot clocks, delay of
game timers, etc here using an RJ11 connector.
USB (Console V4.00+ Only)
Connect to a computer to update console version and advanced console
setup functionality.
Radio Antenna
Radio Antenna screws into the backplate
above the Timer Pendant Switch.
For best results, aim antenna straight up to
the ceiling or sky - do not aim directly at
scoreboard.
TRANSMITTER MODULE FCC ID:KQL-PKLR2400-200 IC:22683911808A3 17
WARNING! This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including
interference that may cause undesired operation.
WARNING! This equipment has been approved for mobile applications where
equipment should be used at distances greater than 20cm from the human body
(with the exception of hands, wrists, feet and ankles). Operation at distances less
than 20cm is strictly prohibited. Excessive RF exposure should be avoided.
RJ11 RJ11
Pendant Switch
Plug in the pendant switch to bypass
the start/stop key for the timer.
3