- ページ 5

エアコン Fujitsu UTY-RNRUZ2のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Fujitsu UTY-RNRUZ2 26 ページ。 Remote controller (wired type)
Fujitsu UTY-RNRUZ2 にも：インストレーション・マニュアル (11 ページ)

ページを印刷する

2 Password configuration

This unit can set the following 2 kinds of passwords:

(a) Password

This is a password for administrator. Password is re-

quested by the setting which requires management. For

a description of password setting and change, refer to

[3. SETTING] →[3.8 Initial Setting]→[3-8-6 Password

Setting] .

(b) Installer password

This password is requested for important settings at

installation.

Note

If you forget your password, contact your local dealer.

3 Name of parts

(a)

(b)

(c)

(d)

(a) Touch panel display

• When the screen is touched or the Operation button

is pressed while backlight is set to Enable, backlight

lights. Backlight goes off 30 or 60 seconds after the

last operation. When backlight is set to Disable, it does

not light. For a description of backlight setting, refer to

[3 SETTING]→[3-7 Preference]→[3-7-2 Backlight Set-

ting].

• Lightly touch the touch panel with your finger tips. A

commercially available stylus pen can also be used.

If pushed with too much force or operated with a

rod, pencil, or ballpoint pen, etc., the display may be

scratched or damaged.

• Do not touch 2 or more places simultaneously. Correct

operation cannot be performed.

• When cleaning the touch panel display, setting child

safety lock prevents erroneous operation. (Refer to

[1 MONITOR] → [1-1 Monitor] → [1-1-4 Child Lock].)

When cleaning, do not use detergent or alcohol, paint

thinner, etc. It will cause accidents or loss of appear-

ance.

(b) LED lamp (Operation indicator)

Lights while the indoor unit is operating. Blinks when an

error is generated.

Switches the occupied state. Refer to [1 MONITOR] →

[1-1 Monitor] → [1-1-1 Monitor Mode Screen] and Refer

to [4 OPERATION TIPS] → [4-5 Occupied state].

(d) Room temperature sensor (inside)

Setting is necessary to use this sensor. Refer to [3

SETTING] → [3-8 Initial Setting] → [3-8-5 R.C. Sensor

Setting].

En-4