ページを印刷する
24
Problem
You cannot open
the appliance
door.
The appliance
makes an unusual
noise.
The appliance fills
with water and
drain immediately.
The washing re-
sults are not satis-
factory.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
SERVICE
We recommend that you write the in-
formation here:
Model
(MOD.)
Possible cause
The washing programme
is in operation.
There is water in the
drum.
Incorrect level of the ap-
pliance.
You did not remove the
packaging and/or the
transit bolts.
The load is very small.
The end of the drain
hose is too low.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
..................
Possible solution
Let the washing programme end.
Set the drain or the spin pro-
gramme.
Adjust the level of the appliance.
Refer to 'Installation'.
Remove the packaging and/or
the transit bolts. Refer to 'Instal-
lation'.
Add more laundry in the drum.
Make sure that the drain hose is
in the correct position.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
If the display shows other alarm codes,
contact the service centre.
• Refer to the information supplied
with this appliance for guarantee
condition and point of contact. The
information to give to the service is
on the rating plate.
Product number
(PNC)
Serial number
(S.N.)
..................
..................