- ページ 18

ストレージ Fujitsu ETERNUS DX60 S3のPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu ETERNUS DX60 S3 28 ページ。 Hybrid storage systems, all-flash arrays, power synchronized unit
Fujitsu ETERNUS DX60 S3 にも：設定マニュアルサーバー接続 (12 ページ), 設定マニュアル (13 ページ), サイト・プランニング・マニュアル (41 ページ), 安全上のご注意 (12 ページ)

Chapter 6

Installing the iSCSI Software Initiator and Setting Up the Server

6.2

Setting Up the Server

Confirm the iSCSI Initiator name.

Use the "iscsiutil" command to check the iSCSI Initiator name.

The iSCSI Initiator name shown here is used for the ETERNUS DX settings.

# iscsiutil -l

Save the statically-recognized iSCSI target information in the kernel registry.

Use the "iscsiutil" command to save the iSCSI target information.

# iscsiutil [iscsi-device-file] -a -I <ip-address>

Example:

For an ETERNUS DX with a connection target iSCSI port IP address of 192.1.1.120:

# iscsiutil -a -I 192.1.1.120

Confirm the iSCSI target information is now in the kernel registry.

# iscsiutil -p -D

Set whether CHAP authentication is to be used or not.

If CHAP authentication is to be performed, set "CHAP". If CHAP authentication is not required, set

"None".

Example:

When CHAP authentication is not used:

# iscsiutil -t authmethod None

Note:

# iscsiutil -t authmethod CHAP None

The above command sets CHAP authentication to operate according to the ETERNUS DX setting. The

CHAP authentication method is selected if the ETERNUS DX uses CHAP for its responses, otherwise CHAP

authentication is not performed.

FUJITSU Storage ETERNUS DX Configuration Guide -Server Connection- (iSCSI) for HP-UX

[-P <tcp-port>][-M <portal-grp-tag>]

P3AM-3402-14ENZ0