- ページ 10

ストレージ Fujitsu Eternus DX80 S2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Fujitsu Eternus DX80 S2 18 ページ。 Server connection. (fibre channel) for aix
Fujitsu Eternus DX80 S2 にも： ユーザーマニュアル (35 ページ), ユーザーマニュアル (42 ページ), セットアップ (20 ページ), 設定マニュアル サーバー接続 (13 ページ), ハードウェアのインストール (23 ページ), 設定マニュアル (28 ページ), 設定マニュアル (15 ページ), 設定マニュアル (38 ページ)

ページを印刷する
Fujitsu Eternus DX80 S2 マニュアル
Cable Connection
S T E P
Various cables need to be connected to the rear of the ETERNUS DX Disk storage system.
●
Point
●
The cables should never be bent, twisted or pulled.
IMPORTANT
LAN Cable (for Operation Management)
Connect a LAN cable (for operation management) to each MNT port.
Cable
-Installation- "4.1 LAN Cable Connection (For Operation Management)"
Host Interface Cable
Connect a Host Interface cable to each of these ports.
Cable
FC, iSCSI 10Gbit/s, FCoE
●
(for FC cable connection)
iSCSI 10Gbit/s, FCoE
●
(for Copper Twinax cable
connection)
1Gbit/s iSCSI
●
SAS
●
-Installation- "4.2 Host Interface Connection"
To help with cable management and prevent incorrect connection, attach labels to the cables and make a
note of connection origins and destinations.
This step describes dual controller type as an example. Note that there is only controller 0 (CM#0) for single
controller type.
Rear view
Rear view
1Gbit/s iSCSI
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
Copyright 2013 FUJITSU LIMITED
Controller (CM#0)
RMT port
MNT port
CA#0
CA#1
FC, iSCSI 10Gbit/s, FCoE
(for FC cable connection)
Port#0
Port#1
Port#0 Port#1
10
Controller (CM#1)
Controller enclosure
RMT port
MNT port
CA#0
CA#1
Controller enclosure
iSCSI 10Gbit/s, FCoE
(for Copper Twinax cable connection)
Port#0
Port#1
SAS
Port#0
Port#1
P3AM-4872-11EN