ページを印刷するProblem
Water flows on the rear plate of the
refrigerator.
There is too much condensed water
on the rear wall of the refrigerator.
Water flows inside the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.
8.2 Replacing the lamp
The appliance is equipped with a long-life
LED interior light.
It is strongly recommended to use
original spare parts only.
Possible cause
During the automatic defrosting
process, frost melts on the rear
plate.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
Food products prevent the water
from flowing into the water collector.
The water outlet is clogged.
The melting water outlet is not con‐
nected to the evaporative tray above
the compressor.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The door has been opened often.
There is no cold air circulation in the
appliance.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
Disconnect the plug from the mains
socket.
1. Pull the left side of the lamp cover with
Solution
This is correct.
Open the door only when necessa‐
ry.
Make sure the door is closed com‐
pletely.
Wrap food in suitable packaging be‐
fore storing it in the appliance.
Make sure that food products do not
touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Refer to "Closing the door" section.
Let the food products temperature
decrease to room temperature be‐
fore storage.
Store less food products at the
same time.
Open the door only if necessary.
Make sure that there is cold air cir‐
culation in the appliance. Refer to
"Hints and tips" chapter.
CAUTION!
your fingers to unlock it. Remove the
cover by pulling it towards yourself.
ENGLISH
13