- ページ 4

調理器 Indesit K3C36/GのPDF 取付・使用説明書をオンラインで閲覧またはダウンロードできます。Indesit K3C36/G 17 ページ。 Cooker with electric ventilated oven and ceramic hob

ページを印刷する

The following instructions should be read by a qualified technician

to ensure that the appliance is installed, regulated and technically

serviced correctly in compliance with current regulations.

Important: disconnect the cooker from the electricity when

making any adjustement, maintenance operation, etc.

Positioning

The appliance can be installed next to furniture units which are

no taller than the top of the cooker hob. For proper installation of

the cooker, the following precautions must be taken:

a) Kitchen cabinets installed next to the cooker that are taller

than the top of the hob must be situated at least 200 mm

from the edge of the hob.

b) Hoods must be installed according to the requirements in

the installation manual for the hoods themselves and in any

case at a minimum distance of 650 mm.

c) Place the wall cabinets adjacent to the hood at a minimum

height of 420 mm from the hob (see figure).

d) Should the cooker be installed beneath a wall cabinet, the

latter should be situated at least 700 mm (millimetres) away

from the hob, as shown in the figure.

e) the cut-out for the cooker cabinet should have the dimensions

indicated in the figure.

Min.

Levelling your appliance (only on a few models)

Your cooker is supplied with feet for levelling the appliance. If

necessary, these feet can be screwed into the housings in the

corners of the cooker base (Fig. A).

Mounting the legs (only on a few models)

Press-fit legs are supplied which fit under the base of your cooker

(Fig. B).

Fig. A

Electrical connection

Electric cookers come without a power supply cable. The cooker

is designed to operate on an electricity supply which conforms

to the electrical data shown on the Rating Plate. The cooker can

be connected to the mains only after removing the back panel of

the cooker itself with a screwdriver.

Installation

HOOD

600

mm.

Fig. B

N.B.: the following installation procedure must be carried out by

a qualified electrician. The electrical installation must comply with

the IEE Regulations, Building & local By-Lays.

For the installation of the feeding cable carry out the following

operations:

Unscrew screw "V" (see fig. C)

Pull and open the junction blok lid

Important: the wires in the mains lead are coloured in

accordance with the following code:

Green & Yellow

Blue

Brown

As the colours of the wires in the mains lead may not correspond

with the coloured markings identifying the terminals in your plug,

proceed as follows:

Green & Yellow wire to terminal marked "E" or

Green or Green & Yellow.

Brown wire to terminal marked "L" or coloured Red.

Blue wire to terminal marked "N" or coloured Black (see fig. D).

fix the feeding cable in the special cable stop and close the

cover.

N.B.: the power supply cable must have these minimum

requirements:

Type:

H05RR-F

Section: 3x4 mm

Fig. C

Connecting the supply cable to the mains

WARNINGS: THIS APPLIANCE MUST BE EARTHED.

Important: The cooker must be connected to the mains by a

switched (double pole) cooker outlet correctly fused with a

capacity appropriate to that shown on the cooker Rating Plate.

All electrical wiring from the consumer unit to the cooker, via the

switched double pole cooker outlet, must be of an acceptable

type and current rating as above.

Note: the supply cable must be positioned so that it never reaches

at any point a temperature 50°C higher than the room tempera-

ture. The cable must be routed away from the rear vents.

Earth

Neutral

Live

or coloured

Fig. D

HOT PARTS