- ページ 18

冷凍庫 AEG 6000 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AEG 6000 Series 24 ページ。
AEG 6000 Series にも：ユーザーマニュアル (12 ページ), ユーザーマニュアル (24 ページ), ユーザーマニュアル (24 ページ)

ページを印刷する

www.aeg.com

Problem

DEMO appears on the dis-

play.

shown instead of numbers

on the temperature display.

If the advice does not lead

to the desired result, call the

nearest Authorized Service

Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

Possible cause

The food products' tempera-

ture is too high.

Many food products are stor-

ed at the same time.

The door has been opened

often.

The Coolmatic function is

switched on.

There is no cold air circula-

tion in the appliance.

The appliance is in demon-

stration mode.

Temperature sensor prob-

symbol is

lem.

Solution

Let the food products tem-

perature decrease to room

temperature before storage.

Store less food products at

the same time.

Open the door only if neces-

sary.

Refer to "Coolmatic func-

tion" section.

Make sure that there is cold

air circulation in the appli-

ance. Refer to "Hints and

Tips" chapter.

Keep the OK key pressed for

approximately 10 seconds

until a long sound is heard

and the display turns off for

a short time.

Contact the nearest Author-

ized Service Centre (the

cooling system will continue

to keep food products cold,

but temperature adjustment

will not be possible).

8.3 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

installation instructions.

3. If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.