- ページ 8

冷凍庫 AEG Table Top FreezersのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。AEG Table Top Freezers 14 ページ。 Table top freezers
AEG Table Top Freezers にも：取扱説明書 (16 ページ)

ページを印刷する

Your freezer needs air

Fig. 4

The cooling unit is designed for maintenance-free

operation.

What it should never lack is good ventilation. Air is

drawn in under the door, through the ventilation slits

in the plinth, through the gap between the appli-

ance and the wall, and passes out through the air

outlet

grille on top. Never obstruct these openings.

If the freezer is installed under a continuous work-

surface, an air outlet must be provided of at least

200 cm

and a grille (C/D) provided to suit the

design of the worktop (Fig. 4 ).

The cut surface of the worktop (E) must be painted

in order to prevent moisture entering and distorting

it.

The minimum clearance between the appliance and

the wall should be at least 30 mm, and should be

checked before the air-outlet grille is ﬁtted.

Special accessories:

C Air outlet grille, brown (E-No. 621 814 002)

D Air outlet grille, white (E-No. 621 825 004).

Removing the worktop

Fig. 5

After removal of the worktop of your table-top

freezer the appliance can be installed under a

continuous worktop.

P ro c e e d a s d e s c r i b e d h e re : U n s c re w t h e

cross-head screws (F) on the right and the left.

Lift the worktop slightly, move it about 5 mm

towards the rear, and lift it out upwards (G).

Unscrew the worktop holders (H) and keep them in

a safe place.

Mounting under a continuous

worktop

Fig. 6

If the appliance is to be installed under a continuous

worktop, it needs to be fastened in place on the

right and the left with a fastening screw (F) which

passes through the elongated hole of the door

mounting. The mounting screws of the removed

worktop can be used for this purpose.

Changing over the door hinges

Figs. 7 to 9a

Before connecting your freezer to the power supply,

you should check whether the door must be

rehinged to open from the right (as delivered) to

opening from the left, if this is required by the instal-

lation position or for ease of operation.

1. Tilt the appliance backwards.

2. Pull the plinth panel off from in front.

3. Unscrew the door bearing (K) and take the door

bearing (1) off downwards out of the pivot hole.

4. Open the door slightly and take it off down-

wards. Place it aside and protect it against dam-

age.

5. Unscrew the upper swivel pin (2) and screw it

into place on the other side again.

6. Fit the door into the upper swivel pin (2) and

close it.

7. Fit the door mounting pin of the door mounting

(1) into the left-hand pivot hole and screw the

door mounting in with the screws (K).

8. Transfer the separate ﬁtment (L),of the plinth

panel from left to right and press the plinth panel

back into the panel holders.

9. Unscrew the handle. Reﬁt it on the opposite side

after having pierced the plugs with a punch.

Cover the holes left open with the plugs con-

tained in the documentation pack.