- ページ 12

換気フード AEG 8160 DのPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。AEG 8160 D 16 ページ。 Cooker hood
AEG 8160 D にも：操作およびインストール手順 (20 ページ), 操作およびインストール手順 (18 ページ), 操作および設置マニュアル (16 ページ)

Mounting the cooker hood - Fig. 7

Position the template on the wall and mark the position, and drill the holes (2

x Ø 8 mm).Mount the two rawl plugs with the hooks (3)

Hang the hood on the hooks and level it with the adjustment screws (4)

Remove the grease filters (5) and mark for the two screws (6). Remove the hood

and drill the holes (2 x Ø 8 mm).

Insert the rawl plugs (7) and hang the hood on the wall again. Adjust it

horizontally with the screws (8) and secure it with the screws (9)

Mount the chimney holder (10) with the rawl plugs (12) and the screws (11).

Be careful that it is centered over the hood and horizontally aligned.

Fitting for ducting (S)

Connect a tube between the hood air outlet and the wall or roof exhaust

channel. Fix it with the tube clamps supplied.

Fitting for recirculation (K)

Mount the recirculation spigot with the two screws supplied.

Mounting the chimney

Place the chimney (15) and fix it to the top chimney holder with the two

screws (16) supplied. Lower the bottom part of the chimney (17) and fasten

it to the top of the hood with two screws, supplied.

Note that the top part of the chimney can be mounted with the side grids up

or down. For use as a recirculation hood it must be mounted with the grids

upwards. (Fig. 6).

Fig. 6