- ページ 6

フロアマシン Aqua Laser Delta Sweeper 815.563のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Aqua Laser Delta Sweeper 815.563 11 ページ。

ページを印刷する

Emptying the dirt tray

Step 1. Make sure the Aqua Laser Delta Sweeper is turned off.

Step 2. With the Sweeper base sitting on the floor or other flat surface such as a countertop,

squeeze and hold the dirt tray lock clips with one hand and lift the sweeper up by its aluminum

pole with the other hand, to release the dirt tray.

Step 3. Empty the dirt and debris into a garbage receptacle.

Step 4. Then, place the dirt tray back on the floor or other flat surface. Lift up and align the base

of the sweeper over the dirt tray. IMPORTANT: if dirt tray does not securely connect back into

place, check to make sure that no small metal debris (e.g. staples, paperclips etc.) has

magnetized to the sweeper's motor located on the underside of the base.

Maintaining your Aqua Laser Delta Sweeper

Over time, as with any rotating bristle cleaning device, the Aqua Laser Delta Sweeper four cleaning

brushes will accumulate fine debris such as hair, tread and other particles. We recommend cleaning the

rotating brushes on occasion using the included brush cleaning tool.

Step 1. Make sure the Aqua Laser Delta Sweeper is turned off and remove the battery to ensure the unit

does not accidentally turn on.

Step 2. Unlock the tinted outer body frame by sliding the two outer body frame lock clips inward towards

the pole.

Step 3. Next, lift the tinted outer body frame up and over the aluminum pole to remove it. The four

brushes are now completely exposed.

Caution: brush cleaning tool has sharp tip and ripping blade. Avoid contact with tip and ripping blade.

Step 4. Use the brush cleaning tool to cut and remove tangled debris. Simply guide the blade

along the shaft of the rotating cleaning brushes. Dispose of debris in garbage.

Step 5. Replace the tinted outer body frame and lock by sliding the outer body frame lock

clips outward and away from the pole.

Periodically wipe down your Aqua Laser Delta Sweeper with a dry or damp lint-free cloth. Do

not use water, liquid cleaners or abrasive materials to clean the Aqua Laser Delta Sweeper.

Basic Troubleshooting

the Aqua Laser Delta Sweeper is sluggish or won't start:

Make sure the battery is fully charged and securely inserted into the battery compartment, and that the

pole section with the battery compartment is securely connected to the pole base.

Battery not charging:

Make sure the battery is fully inserted into the battery charger. Also, check to make sure that the red

indicator light on the battery charger comes on when charging.

the Aqua Laser Delta Sweeper is operating but not picking up mess:

The dirt tray may be full. Empty out if necessary. Also, some debris may be lodged in carpeting (such as

staples) or may be too large/heavy for the sweeper to pick up. Make sure the dirt tray is attached.

Dirt & debris is escaping from sweeper during cleaning :

Make sure the dirt tray is empty and securely connected to the sweeper. Also, check to see that the

rotating cleaning brushes are not entangled with debris such as hair, paper etc. Use the brush cleaning

tool to clean off, if necessary.

Technical data:

AC Adapter input

AC Adapter output

Adapter

Voltage battery

Rated power of appliance

Charging current for empty battery

Operating time with full charge

Correct Disposal of this product

This marking indicates that this product should not be disposed with other household wastes

throughout the EU. To prevent possible harm to the environment or human health from uncontrolled

waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return

your used device, please use the return and collection systems or contact the retailer where the

product was purchased. They can take this product for environmental safe recycling.

230V ~ 50 Hz 35mA

7,5V --- 250mA

1200mAh Ni-MH

7.2 V

6 W.

6-8 H.

60 MIN.