- ページ 4

ネットワーク・ハードウェア AVPro Edge AC-MXNET-10G-SW12CのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。AVPro Edge AC-MXNET-10G-SW12C 8 ページ。 The mxnet 10g sdvoe ecosystem

ページを印刷する

3: Connect the Transceivers to the Network Switch

Once the transceiver modes have been selected and the port types have been configured for

Category or fiber cabling, connect the transceivers to the network switch.

4: Connect the Transceivers to their HDMI devices

Connect the HDMI source devices to the HDMI IN port on the encoders, and the HDMI output devices

to the HDMI OUT port on the decoders.

(Rear Panel)

AC-MXNET-10G-TCVR

On Encoders: Connect to the HDMI

source device with an HDMI cable

Note:

When the transceiver is set to encoder mode, the HDMI OUT port functions as an HDMI Loop Out port.

5: Connect the CBOX to the Network Switch

Connect the SDVoE port on the CBOX

to a 10G SFP+ port on the network

switch (or an SFP28 port on the AC-

MXNET-10G-SW12C).

Connect the PORT 6 (PoE) port to the

LAN, router, or third party control

system for power and/or access to the

Mentor interface.

*If PoE is unavailable, use the DC/12V

power inlet to locally power the CBOX

by connecting it to an electrical outlet.

On Decoders: Connect to the HDMI

output device with an HDMI cable

Page 4 of 8

MXNET 10G SDVoE

Quick Start Guide