- ページ 7

エクステンダー AVProConnect AC-EX70-UHDのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。AVProConnect AC-EX70-UHD 12 ページ。 4k hdmi 2.0 extender with hdcp 2.2
AVProConnect AC-EX70-UHD にも: ユーザーマニュアル (12 ページ), ユーザーマニュアル (16 ページ)

AC-EX70-UHD
※Setting Dip Switch – Initial Setup/Updating Firmware
1. Selector switch is intended for bypassing RS232 signal or for purpose of
firmware update.
2. Serial RS232 selection: Position "Program" for firmware update, "Normal" for
RS232 Command string transmission. Change switch positions to set desired
RS232 port function.
※Update instruction:
① In case of need Device Firmware can be upgraded with supplied
FW-Upgrade package that contains all software needed for burning and
updating the Firmware on the EEPROM.
② Connect an RS232 cable from RS232 port of Extender to PC.
③ Power the unit.
④ Extract the zipped file from the burn package to a directory (e.g.
C:\dir_name).
⑤ Browse to the directory (e.g. C:\dir_name\) and double click the batch file
UpdateSource.bat
AC-EX70-UHD-RX).
⑥ A short description of the link created between the PC and the board
appears on the screen, followed by the update progress report (in %).
⑦ A second stage will be verification of the EEPROM content, also with a
verification progress report (in %).
※For Normal RS232 control signal transmission, just connect
supplied RS232 cables to each end of the extenders RS232 ports
(AC-EX70-UHD-TX and AC-EX70-UHD-RX). This Serial connection will
work bidirectionally as a full featured RS232 extension cable.
(for
AC-EX70-UHD-TX)
7
or
UpdateSink.bat
(for