- ページ 3

はしご Aqua Select 832406SCのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Aqua Select 832406SC 8 ページ。 Heavy duty resin in-pool ladders with entrapment barrier

IMPORTANT SAFETY INSTRUCTIONS

PLEASE READ PRIOR TO ASSEMBLY/USE

The Ladder must be installed based on Manufacturer's Instructions

• One person on the Ladder/Stair at a time

• This Ladder is designed and manufactured for a specific Pool Wall Height

and/or Deck of the Pool

• For Entry/Exit of pool, face the ladder at all times

• Remove and secure Ladder when pool is not occupied

• The Ladder will be suitable up to 54" Maximum Pool Height

• There shall be clearance of Min. 3" and Max. 6" between the Pool Wall and

the Ladder

• There are two sets of lug locations on the stringers in the

areas where each step will be installed. Each step should

be installed into the UPPER set of lugs only.

• Locate one of the four groups of lugs and slide step

(AC MKSTEP) into the upper set of lugs on the legs so

it clicks into place.

• Repeat for each of the remaining (3) steps.

• Secure all by drilling (1) #10 x 1-1/4" screw into each side

of the step through the pre-marked leg openings.

STEP 1

Place the bottom step (AC BTSTEP) on a level surface with

•

indentations facing up.

Take leg (AC 01129) and stand upright (pointed side down).

•

When installed on bottom step, the leg will need to have the

raised areas facing inward. The raised area with the

pre-drilled screw hole should be at the front of the ladder

toward the top of the leg.

•

Place the left leg into the indentation on the left side of the

step and push straight down until it clicks into place.

•

Repeat above for right leg on right side of step.

STEP 2