防犯カメラ AVS SNAP212VIRのPDF マニュアルをオンラインで閲覧またはダウンロードできます。AVS SNAP212VIR 2 ページ。 Hd-sdi vandal-proof & waterproof d&n dome camera

ページを印刷する

AVS Uriel systems Inc.

VA office

13882 Park Center Rd Herndon, VA 20171

Toll:1-(800) 691-1034 Phone: (571) 490-8321

Fax: (571) 490-8328

HD-SDI VANDAL-PROOF &

WATERPROOF

D&N DOME CAMERA

SNAP212VIR

MANUAL

◐ PRECAUTION

1. You can install the camera indoors or outdoors.

2. C hoose an ideal location for the camera, since a camera unit must

be protected against vibration.

3. B e careful not to scratch the camera unit, especially lens or dome

cover.

4. U se the camera within the temperature(-45℃~50℃). [W/

HEATER(option)]

5. Avoid any direct sun light toward the lens.

6. U se the AC adaptor 12V DC, 600mA regulated. Dual voltage

product can use 24V AC, 600mA adaptor.(option)

If the product is to be put out of operation definitively,

take it to a local recycling plant for a disposal which

is not harmful to the environment.

◐ FEATURES

1. 1/2.9" SONY CMOS sensor

2. Full HD Resolution

3. DAY & NIGHT Function

4. WDR (Wide Dynamic Range)

5. 3D DNR Function

6. Privacy mask function 16 area

7. On Screen Display menu

8. Intelligent motion detection 4 area

9. Output : HD-SDI/CVBS

10. Protocol RS-485 : PELCO-P, PELCO -D (Option)

11. IP68(Waterproof)

12. Durable MATERIAL : Body - Aluminum, Dome - Polycarbonate

13. T his camera is incredibly flexible to install with its 3-axis camera

construction, which makes the camera ceiling, wall or slope

mountable

14. 25M range visible in total darkness with 24pcs of IR LEDs.(Indoor)

◐ HOW TO INSTALL

1. Camera installation

(1) F ix the camera set with the supplied screws on ceiling or wall

mount. If you don't use supplied screws, the camera may fall off.

(2) P lease refer to '3. Camera angle adjustment' regarding adjust

camera angle.

(3) L ens adjustment(Vari-focal Lens only)

After opening the LED cover,

① B y turning the "Tele-Wide" knob,

you can access a range of focal

lengths within specified limits.

② S ince then, by turning the "Near-

Far" knob, you can set the focus

toward the wanted object.

(4) Re-assemble the camera.

Ø3.5 Ø30

MOUNT HOLE PLATE(STICKER)

Put a sticker on the ceiling and make holes

according to the spots marked on a sticker

SCREW Tp1 4X25 3EA

MOUNT HOLE PLATE(STICKER)

Put a sticker on the wall and make holes

according to the spots marked on a sticker

SCREW Tp1 4X25 3EA

2. Pipe application

(1) Remove the screw for fixing a cable on the bottom of the base.

(2) Open the DOME COVER.

(3) Remove the TAP COVER and place the cables there.

(4) After distributing cables, use the TEPLON tape to wipe the pipe.

(5) Combine the pipe to the base.

<Caution> I f you don't wipe TEFLON tape on pipe, it might cause

3. Camera angle adjustment :

(1) Pan adjustment : Grasp the disk of camera and then adjust

direction to the right or left(-160°~190°)

(2) Tilt adjustment : Grasp the camera holder and then adjust

direction to the up or down(6°~ 90°)

(3) Roll adjustment : Grasp the camera holder and then rotate

(-178°~178°)

<Caution> I f you try to adjust the camera out of limited angle, it might

Ø30

Ø3.5

◐ DIMENSION

troubles on water-resistant.

PIPE

TAP COVER

CABLE FIXING SCREW

TEFLON TAPE

DOME COVER

cause troubles and damage to camera.

LED COVER

DISK

CAMERA HOLDER

ROTATION

Ø100

Ø150.5

Ø129

CABLE