- ページ 3

除湿機 ABATEMENT AQUATRAP AT100SのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ABATEMENT AQUATRAP AT100S 10 ページ。 Lgr portable dehumidifier

CAUTION: If the unit has been laid on its back, even for short periods of time, it must be

set upright for at least ½ hour before being plugged in and started up. This gives the

compressor oil and liquid refrigerant sufficient time to re-distribute. Failure to do so can

cause premature compressor failure, and voids the compressor warranty.

If extremely poor road conditions exist, or excessive shock and vibration are expected, take

precautionary measures by padding the unit to provide impact absorption during transport.

CAUTION: Always be careful when moving the AT100S inside a building or home. The

unit weighs 125 lbs., so older structures with weakened floors and staircases may

require special considerations for safe transport.

ELECTRICAL REQUIREMENTS

The AT100S is a cord-connected unit that uses a standard grounded NEMA 5-15P plug which is

to be connected to a 115 Volt AC 60 Hz grounded electrical receptacle. The supply voltage

should be between 109 and 121 Volts in order for the unit to function as intended. Performance

ratings are determined at 115 Volts. In circumstances where extreme voltage fluctuations exist,

and have not yet been corrected by the electrical utility, the unit is capable of operating between

104 and 126 volts, when necessary.

Due to momentary start-up current surge, the unit may require a dedicated 15 Amp circuit which

is free of other loads. There is a 0 to 10 second random re-start sequence built into the control

logic that prevents simultaneous start-up of multiple units after a power outage and subsequent

re-energization. If the unit was in operation before a power outage, it will be re-started

automatically, but randomly within 10 seconds, when power resumes.

It is recommended that a Ground Fault Current Interrupt (GFCI) device be used in the electrical

supply circuit. A GFCI is an electrical safety device that will trip the circuit and interrupt the

supply of electricity if leakage of current is detected.

Extension cords used for the AT100S must be Certified (UL, CSA as applicable) heavy duty No.

14/3 AWG grounded industrial-grade type. Use of larger numerical gauge (smaller diameter

wire) wire power cord(s) may result in electric shock, fire hazards, and/or damage to the unit.

The cords must be in good condition, in continuous lengths (no splicing) and should not exceed

a length of 50 feet. Make certain that any extension cords used do not reduce power at the unit

to less than the recommended 109 Volts. Use of a voltmeter to confirm voltage is suggested.

Check to ensure that any circuit to which the unit is connected is protected by a maximum 20

Amp circuit breaker.

To avoid personal injury, fire hazards and/or damage to the AT100S electrical system and

power cord, do not connect or disconnect the power cord to an electrical outlet unless the unit is

"OFF".

Never allow unauthorized individuals or children to operate the unit at any time.

Abatement Technologies urges anyone operating the AT100S to wear the proper personal

protective equipment and follow safe work practices in accordance with federal, state, provincial

and employer regulations.

3 of 10