- ページ 3
モニター avsi citronic CM10のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。avsi citronic CM10 4 ページ。 Stage wedge monitors
Passive panel layout
Active panel layout
Setting up
For live stage monitoring, position your CM-series stage wedge on the floor facing upward toward the listener.
The wedge can also be mounted onto a 35mmØ speaker stand or wall bracket for use as a PA speaker.
The coaxial main driver has an integral tweeter for full-range output from a focused, compact cabinet.
Passive models are connected via either of the two SPK input sockets, wired 1+/1- (pins 2 not connected).
Connect to only one of these from the amplifier (another passive speaker may be connected to the other)
Ensure that the CM passive monitor can handle the power from the amplifier at 8Ω (or 4Ω if 2 are connected).
Active models have 2 independent inputs...
Input A (2, 9) can accept a line level signal from a mixer, audio source or electronic instrument.
The volume level of input A is controlled by the VOLUME A rotary control (15).
Input B (11) is switchable to accept either a microphone directly or a line input via the MIC/LINE button (12).
The volume level of input B is controlled by the VOLUME B rotary control (13).
The overall output level of the monitor is governed by the MASTER volume control (6).
The mix of Input A and Input B (and Bluetooth as described below) can be output to further active speakers
or monitors from the MIX OUT XLR connector (10).
A stereo HEADPHONE output (14) enables personal headphone monitoring, governed by a volume control (7).
Both SPK input sockets are wired to 1+/1- in parallel
1.
2.
3.
4.
5.
6.
7.
8.
9.
10. MIX line output XLR
11. MIC/LINE B input combo Jack/XLR
12. Input B MIC/LINE level selector
13. MIC/LINE B volume control
14. HEADPHONE 6.3mm stereo output
15. LINE A volume control
16. IEC mains inlet & fuse holder
DSP setting indicator LEDs
LINE A input combo Jack/XLR
Bluetooth on/off & pairing button
DSP rotary selector
Bluetooth & Amplifier status LEDs
MASTER volume control
HEADPHONE output volume control
Power on/off switch
LINE A input RCA (L+R)
CM-series Stage Wedge Monitor User Manual