- ページ 13

スクラバー Abatement Technologies HEPA-AIRE PAS1200のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Abatement Technologies HEPA-AIRE PAS1200 18 ページ。 Portable air scrubber

ページを印刷する

1. Pas1200 Diagrams

PROBLEM

No response when the

power is turned on

Circuit breaker on

control panel or

building "trips".

Filter change indicator

is ON".

Note: If the unit does not start or malfunctions after carefully following the TROUBLESHOOTING GUIDE, call

Abatement Technologies service department at +1 800-634-9091 (U.S.) or +1 905-871-4720 (Canada) for

assistance.

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE

Power cord unplugged.

Defective power cord.

Tripped circuit breaker.

Tripped ground fault circuit

interrupter or residual current

device.

Thermal overload on the

motorized impeller has tripped.

Overloaded circuit.

Loaded filters.

Excessive restrictions.

If using a carbon pre-filter,

carbon filter has not been

removed from polybag.

SOLUTION

Plug power cord firmly into electrical outlet in

wall.

Check all connections and condition of cords.

Do not operate with damaged power cord(s).

Reset breaker for building.

Reset 12 amp breaker located on unit.

Reset GFCI on control panel or GFCI/RCD at

the power source.

Note: Unit must be plugged in when resetting

GFCI on control panel.

Turn unit "OFF", wait 30 minutes and restart

unit.

Unplug any additional equipment connected

to the circuit. Reset circuit breaker.

Change in accordance with operating

instructions.

Reduce bends, length of flex duct, or

eliminate restrictions.

Remove carbon filter from polybag.