- ページ 24
デスクトップ Dell D11SのPDF セットアップと仕様をオンラインで閲覧またはダウンロードできます。Dell D11S 35 ページ。 Small form factor
Dell D11S にも： クイック・スタート・マニュアル (2 ページ), オーナーズマニュアル (45 ページ), セットアップおよび仕様マニュアル (35 ページ), インストレーション・マニュアル (22 ページ), セットアップと仕様 (37 ページ), セットアップおよび仕様マニュアル (31 ページ)
ページを印刷する
Power management
Table 23. Power Management
Option
AC Recovery
Enable Intel Speed Shift
Technology
Auto On Time
Deep Sleep Control
Fan Control Override
USB Wake Support
Wake on LAN/WWAN
Block Sleep
Post behavior
Table 24. POST Behavior
Option
Numlock LED
Keyboard Errors
Fast Boot
24
System setup
Description
Determines how the system responds when AC power is re-applied after a power loss. You can set
the AC Recovery to:
•
Power Off
•
Power On
•
Last Power State
This option is set to Power Off by default.
Allows you to enable or disable Intel Speed Shift Technology support. The option Enable Intel
Speed Shift Technology is set by default.
Sets time to automatically turn on the computer. Time is kept in standard 12-hour format
(hour:minutes:seconds). Change the startup time by typing the values in the time and AM/PM
fields.
NOTE:
This feature does not work if you turn off your computer using the switch on a
power strip or surge protector or if Auto Power is set to disabled.
Allows you to define the controls when Deep Sleep is enabled.
•
Disabled (default)
•
Enabled in S5 only
•
Enabled in S4 and S5
The option is not set by default
Allows you to enable the USB devices to wake the computer from standby mode. The option
"Enable USB Wake Support" is selected by default
This option allows the computer to power up from the off state when triggered by a special LAN
signal. This feature only works when the computer is connected to AC power supply.
•
Disabled - Does not allows the system to power on by special LAN signals when it receives a
wake-up signal from the LAN or wireless LAN.
•
LAN or WLAN - Allows the system to be powered on by special LAN or wireless LAN signals.
•
LAN Only - Allows the system to be powered on by special LAN signals.
•
LAN with PXE Boot - A wakeup packet sent to the system in either the S4 or S5 state, that
will cause the system to wake-up and immediately boot to PXE.
•
WLAN Only - Allows the system to be powered on by special WLAN signals.
This option is set to Disabled by default.
Allows you to block entering to sleep (S3 state) in OS environment. This option is disabled by
default.
Description
Allows you to enable or disable the Numlock feature when your computer starts. This option is
enabled by default.
Allows you to enable or disable the keyboard error reporting when the computer starts. The option
Enable Keyboard Error Detection is enabled by default.
This option can speed up the boot process by bypassing some compatibility steps: