- ページ 7

メディア・コンバーター Avtron HS6MのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Avtron HS6M 16 ページ。 Hollow shaft 6-15mm

Speed measurement is deactivated by default.

To enable speed measurement: write 0x01 to SDO object 0x3010,

subindex 1, and write the speed modulus to subindex 2.

To read the speed after activation: read SDO object 0x3011 (8 bit

unsigned) or SDO object 0x6030.

Acceleration measurement is not supported. SDO object 0x3021

and 0x6040h are reserved for future use but do not indicate

acceleration at this time.

Setting Polling, Cyclic and Sync Mode

Polling, cycling and sync mode are supported by the encoder; use

the parameters supplied in the EDS file to set the appropriate mode.

Store the resulting configuration into the scanner module.

Storing/Saving Encoder Parameters

To store the current encoder operating parameters into non-volatile

memory:

Write 0x55 0xAA 0xAA 0x55 to SDO object 0x2300

Example, encoder at node 20, store changes

ID: 0x620 0x22 0x00 0x23 0x00 0x55 0xAA 0xAA 0x55

No reset is triggered.

Cycle power after saving changes to parameters.

Other Parameters

Contact Nidec Avtron for additional parameters, diagnostic registers,

cam and programmable limit switch functionality and other

advanced features.

HS6M