- ページ 17
サーバー Dell Force10 S25PのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S25P 48 ページ。 Installing the s25p system
Dell Force10 S25P にも： クイック・スタート・マニュアル (27 ページ)
ページを印刷する
Chapter 3
To install the S25P system, Force10 Networks recommends that you complete the installation procedures
in the order presented in this chapter:
•
Inserting Optional Modules (10-Gigabit or Stacking)
•
Installing the Switch on a Tabletop on page 19
•
Installing the Switch in a Rack or Cabinet on page 19
•
Stacking on page 24
•
Supplying Power on page 27
—
S25P-DC on page 28
Warning:
As with all electrical devices of this type, take all the necessary safety precautions to prevent
injury when installing this system. Electrostatic discharge (ESD) damage can occur if components are
mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the S25P and its
components.
Inserting Optional Modules (10-Gigabit or Stacking)
The S25P (catalog name S25
there are four modules available:
Module Description
2-port 10GbE XFP (optical connection)
2-port 10GbE CX4 (copper connection)
2-port 12GbE Stacking
1-port 24GbE Stacking
The system supports inserting the modules in any combination of slots (although connecting all four ports
of two 12G stacking modules is not supported, nor is connecting one kind of stack port to anything other
than the same kind of stack port). The ports are numbered 25 through 28, from left to right as you face the
front of the chassis. So, for clarity in the use of the CLI in port assignment, if you are only using one XFP
or CX4 module, insert it in the left-most expansion slot.
Note: The 10G modules cannot be used for stacking. See
Installing the S25P System
Installing the S25P
has two expansion slots in the back of the chassis, for which
-01-GE-24P)
Catalog Name
S50-01-10GE-2P
S50-01-10GE-2C
S50-01-12G-2S
S50-01-24G-1S
Connecting Stack Ports (optional) on page
25.
17