- ページ 3

サーバー Dell PowerEdge PDU Metered LCDのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell PowerEdge PDU Metered LCD 11 ページ。 Site planning guide
Dell PowerEdge PDU Metered LCD にも：マニュアル (11 ページ), マニュアル (11 ページ), マニュアル (9 ページ), サイト・プランニング・マニュアル (8 ページ)

ページを印刷する

Cable Routing Procedures for the Dell PowerEdge R520 System

Contents

Introduction ............................................................................................................. 4

Section 1: Cabling a PowerEdge R520 system with a CMA ....................................................... 4

1.1.

Connecting the cables to the system ................................................................... 4

1.2.

Routing the power cables through the strain reliefs ................................................. 5

1.3.

Installing the CMA .......................................................................................... 5

Section 2: Replacing a hot swap power supply on a PowerEdge R520 system with a CMA ............... 8

2.1.

Replacing a hot swap power supply with a left-side mounted CMA ............................... 8

2.2.

Replacing a hot swap power supply with a right-side mounted CMA ............................. 8

Section 3: Cabling a PowerEdge R520 system on sliding rails without a CMA ............................. 10

3.1.

Routing the cables ....................................................................................... 10

3.2.

Removing the outer CMA brackets for shallow racks .............................................. 10

Section 4: Cabling a PowerEdge R520 system installed on static rails ..................................... 11

Figures

Figure 1.

System with cables installed ............................................................................. 4

Figure 2.

Routing power cables through the strain reliefs on hot swap power supplies .................. 5

Figure 3.

Routing the power cable through the strain relief on a fixed power supply .................... 5

Figure 4.

Attaching the inner CMA attachment bracket ........................................................ 6

Figure 5.

Routing the cables through the CMA .................................................................... 6

Figure 6.

Left-side mounted CMA installation (preferred) ...................................................... 7

Figure 7.

Right-side mounted CMA installation (CMA shown in service position) ........................... 7

Figure 8.

Disconnecting the CMA attachment housings ......................................................... 9

Figure 9.

Replacing a hot swap power supply ..................................................................... 9

Figure 10. Cable routing on sliding rails without a CMA ........................................................ 10

Figure 11. Removing the outer CMA brackets for shallow racks .............................................. 11

Figure 12. Cabling a system installed in static rails ............................................................. 11