- ページ 11

スイッチ Dell Force10 S60 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Dell Force10 S60 Series 45 ページ。
Dell Force10 S60 Series にも：クイック・スタート・マニュアル (29 ページ)

Install the S60 System

To install the S60 system, Dell Force10 recommends completing the installation procedures in the order

presented in this chapter.

Always handle the S60 system and its components with care. Avoid dropping the system or its Field

Replaceable Units (FRUs).

This chapter describes the installation procedures as follows:

Install the Chassis into the Rack or Cabinet

Attach the Ground Cable

Insert Optional Modules

Connect Stacking Ports (Optional)

Supply Power and Power Up the System

WARNING: Electrostatic discharge (ESD) damage can occur if the components are mishandled. Always wear

an ESD-preventive wrist or heel ground strap when handling the S60 system and its components. As with all

electrical devices, take all the necessary safety precautions to prevent injury when installing this system.

Install the S60 System in a Rack or Cabinet

Attach the Mounting Brackets

The S60 system is shipped with mounting brackets (rack ears) and the required screws for rack or cabinet

installation. The brackets are enclosed in a package with the chassis.

NOTE: Dell Networking recommends attaching the brackets to the front of the chassis on the Power Supply

Unit (PSU) side. This provides the greatest weight support for the chassis in the rack or cabinet and is in

compliance with Bellcore Zone 4 earthquake requirements.

Install the S60 System