- ページ 7

ウィンドウ・ブラインド 3 Day Blinds ROLLER SHADEのPDF はじめにをオンラインで閲覧またはダウンロードできます。3 Day Blinds ROLLER SHADE 8 ページ。 Continuous cord loop and link system with cassette, continuous cord loop with side channels

ページを印刷する

OPTIONAL ACCESSORIES

EXTENSION BRACKETS

Extension Brackets are used to project the shade up to 3"

from the mounting surface. Extension brackets are available

at an additional charge and are ideal if your shade must clear

an obstruction such as a sliding glass door handle or window

crank. Extension brackets require a flat vertical mounting

surface of at least ⅞ ".

To assemble and mount

• Attach each mounting bracket to an extension bracket by

using the nuts bolts and washers provided.

• Mount the extension bracket to the wall per the instructions

for an "Outside Mount", using a level and making certain

that all mounting brackets are level and project the same

distance from the mounting surface. For maximum stability,

install the screws diagonally from one another.

• Install the shade per the directions for "Shade Installation".

SPACERS

Spacers are available for use on windows with a projected

molding. They are ⅜ " thick and allow the shade to be

mounted flush with the outside edge of any standard window

molding. They are available by contacting our Customer Care

Department at 800-800-3329.

| Cassettes and Side Channels

HOLD DOWN BRACKETS

Hold down brackets are used primarily on shades mounted to

doors or in motor homes. There are two small holes in the end

caps. Use the pin on the hold down bracket to push through

the hole in the end cap.

• With the shade lowered to it's full length, place the pin of

each hold down bracket into the hole in each end of the

bottom rail.

• Mark the mounting surface, either to the side or back of the

window frame, through the holes in the hold down bracket.

Make sure the hold down brackets are level and aligned with

each other.

• Raise the shade and screw the hold down brackets into the

mounting surface using the screws provided.

• Lower the shade and fl ex the

hold down bracket outward

so that the pin can be

inserted into the hole in the

end cap.