- ページ 25

換気フード Miele DA 3160のPDF 操作およびインストール手順をオンラインで閲覧またはダウンロードできます。Miele DA 3160 40 ページ。 Ventilation system
Miele DA 3160 にも：操作およびインストール手順 (36 ページ), 寸法 (1 ページ), 操作およびインストール手順 (40 ページ), 操作およびインストール手順 (40 ページ), 操作およびインストール手順 (40 ページ), 操作およびインストール手順 (40 ページ)

Positioning the appliance in

the wall housing unit

To position the appliance correctly,

cut the spacer strip to required depth

T, and then attach it to the back of

the appliance.

T= Depth of carcase K minus depth of

appliance G

^ The depth of appliance G depends

on the lightshield being used:

–

Lightshield to match existing

kitchen furniture

–

DFB lightshield (optional

accesssory)

–

No lightshield.

This is based on a lightshield which

aligns with the front edge of the

carcase.

If the lightshield is further forward or

back, measurement T will need to be

adjusted accordingly.

When installing an interim shelf or

partition wall, the building-in space at

the back must not be less than

180 mm.

If it is less than 180 mm, position the

appliance further back, and reduce

measurement T accordingly. The

building-in position can be rectified

later by adjusting the depth.

^ Cut the spacer strip supplied to

measurement T.

Score along the groove for the

smaller measurement as shown, and

remove the surplus.

^ Screw the spacer strip to the bottom

of the sides of the housing, flush with

the rear wall.

^ Draw a vertical line up both inside

walls of the housing from the front of

the spacer strip.

Installation