- ページ 9

アンプ ALLNIC AUDIO A-2000のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。ALLNIC AUDIO A-2000 13 ページ。 Kt150 push-pull stereo power amplifier
ALLNIC AUDIO A-2000 にも：オーナーズマニュアル (9 ページ)

ページを印刷する

If a meter's needle drops to the left limit of the meter's face during operation, this indicates a failure of the related

KT150 tube. You must turn off the A-2000 SE and replace both the fuse (0.5A, 250V, 20mm slow-blow) for that tube

and the KT150 itself. To replace a fuse, using a screwdriver, simply turn the top of the fuse cap counter-clockwise. It

will spring out holding the fuse. Replace the fuse, push the fuse cap down and turn it clockwise; it will lock itself. If

you have any questions about doing this, please contact Your Allnic dealer for assistance.

If the AC mains fuse, located at the IEC input, has failed, it can be replaced with the spare fuse (5A, 250V, 20mm

slow-blow) provided in the tray in the IEC mount. Again, if you have any questions about doing this, please contact

Your Allnic dealer for assistance.

Of course, you will have to adjust the bias back into the area between the two parallel lines of the meter for a tube

when it is replaced. When replacing a KT150, first turn the bias screw counter-clockwise slightly to reduce current,

in case the bias is set too high for the new tube (since the old tube may have required additional bias). Bring the

bias up gradually to the middle between the two lines on the meter.

All consequences of changing or attempting to change tubes are borne by the user unless by express agreement

between the owner and an authorized Allnic representative. Allnic Audio and its authorized representatives are not

liable in any way whatsoever for any injury or loss incurred by the user or for damage to the A-2000 25

Anniversary SE, any of its parts, or tubes or replacement tubes resulting from the user changing or attempting to

change tubes.

SPECIFICATIONS FOR THE ALLNIC AUDIO A-2000 25

•

Output Power:

•

Distortion:

•

Frequency Response:

•

S/N Ratio:

•

Damping Factor:

•

Voltage gain:

•

Input Impedance:

•

Input Sensitivity:

•

Fuses:

ANNIVERSARY SE KT150 STEREO POWER AMPLIFIER

• 100w (8Ω load, at 1KHz) Beam Tetrode

• 50w (8Ω load, at 1KHz) Triode

• 0.17% at 1KHz at 10w

• 20Hz - 20KHz Flat

• -80dB (CCIR, 1KHz)

• 8 at 8Ω load at 1KHz

• +26dB

• 100KΩ (single-ended, unbalanced)

• 1.3V for maximum rated power

Mains:

AC 3A, 250V slow-blow for 110/120V regions

AC 2A, 250V slow-blow for 230/240V regions

KT150: 0.5A, 250V, 20mm slow-blow