- ページ 9

アンプ ALLNIC AUDIO A-2500のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。ALLNIC AUDIO A-2500 14 ページ。 211/845 single-ended triode monoblock power amplifiers

To bias the power tube properly by centering the meter's needle between the meter's main parallel lines,

use an appropriately bladed screwdriver to adjust the bias control directly in front of the 211/845 by

turning the yellow plastic screw clockwise or counterclockwise. If the needle of a current meter for the

211/845 has moved to the left of the parallel lines on the meter's face, adjust the bias control by turning

the plastic screw clockwise until the needle has returned to centre between the meter's parallel lines. If

the meter needle has moved to the right of the parallel lines on the meter face, turn the bias control

counterclockwise to correct.

If the meter's needle drops to the left limit of the meter's face during operation, this indicates a failure of

the related 211/845 tube. You must turn off the A-2500 and replace the 211/845 and, probably, the

protection fuse (0.5A, 250V, 20mm slow-blow) for the tube. To replace the fuse, using a screwdriver,

simply turn the top of the fuse cap (located just behind the 211/845 tube – see Figure 4) counterclockwise.

It will spring out holding the fuse. Replace the fuse, push the fuse cap down and turn it clockwise; it will

lock itself. If you have any questions about doing this, please contact your Allnic dealer for assistance.

If the 5.0 Amp AC mains fuse, located at the IEC input, has failed, it can be replaced with the spare fuse

provided in the tray in the IEC mount. Again, if you have any questions about doing this, please contact

your Allnic dealer for assistance.

Of course, you will have to adjust the bias back into the area between the two parallel lines of the meter

for a tube when it is replaced. When replacing a 211/845, first turn the bias control counterclockwise

slightly to reduce current, in case the bias is set too high for the new tube (since the old tube may have

required additional bias). Bring the bias up gradually to the middle between the two lines on the meter.

All consequences of changing or attempting to change tubes are borne by the user unless by express

agreement between the owner and an authorized Allnic representative. Allnic Audio and its authorized

representatives are not liable in any way whatsoever for any injury or loss incurred by the user or for

damage to the A-2500s, any of their parts, or tubes or replacement tubes resulting from the user

changing or attempting to change tubes.