- ページ 11

包装設備 ALLpaQ Packaging Group Genesis SeriesのPDF オペレーター・ユーザー・マニュアルをオンラインで閲覧またはダウンロードできます。ALLpaQ Packaging Group Genesis Series 13 ページ。

ALLpaQ Genesis 200E Only

Once the container is unfolded remove the padded detachable ﬂoor panel and place safely near

the unit avoiding any marked walkways.

Fig 2.6

This will reveal a steel frame in the collapsed position (Fig 2.6).

Lift frame and unfold legs to each corner of the container and ensure white legs are at the rear of

the container Fig (2.7)

Replace detachable padded ﬂoor panel (Fig 2.8) and container is ready for use.

3.3 Fitting the port position plate to the bag

The procedure for ﬁtting the port position follows the same procedure for the 500L & 1000L

versions of the ALLpaQ Genesis range.

ALLpaQ recommend that all 3D bags used in conjunction with it bioprocess range of containers

should be ﬁtted with a small plastic support disc when ﬁlled. Some bags may be pre ﬁtted with a

similar disc however if this is not the case please contact ALLpaQ immediately before use.

For full instructions see 1.3

Fig 4.1

Fig 4.2

Fig 2.7

Front

3.4 Fitting the bag

Instruction applies for the ALLpaQ Genesis 200E (Fig 4.1)

and ALLpaQ Genesis 250 (Fig 4.2).

To access the container operator can reach over the side

panels to position the bag.

Feed the drain tubing through the hole in the base of the

container.

It may be helpful to pull the tubing through the front of the

base via the access door (Fig 4.2 inset).

Manual V1 - (Sept 14

Fig 2.8

Any tubes and clamps should be

closed/open in according to

manufacturers recommendations.

2012)