- ページ 19
溶接アクセサリー Miller ArcReach SuitCase 12のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Miller ArcReach SuitCase 12 48 ページ。
ページを印刷する
5-6. Connecting Welding Gun And Voltage Sensing Clamp
1
Gun Locking Tab In Place
Internal Side View
8
5
2
Gun Locking Tab Out Of Place
4
3
6
!
Turn Off wire feeder and
welding power source.
Stop engine on welding
generator.
!
Weld voltage is present at
voltage sensing clamp
when wire feeder and
welding power source are
on. This condition exists
even if wire feeder light
and meters are off.
5
!
Turn off wire feeder or
welding power source be-
fore handling or moving
voltage sensing clamp.
1
Gun Securing Knob
2
Gun Block
3
Gun Power Pin
4
Power Pin Groove
5
Gun Locking Tab
Loosen gun securing knob, insert
gun power pin into gun block. Po-
sition power pin as close as pos-
sible to drive rolls without touch-
ing. Align the gun power pin
groove with the gun locking tab.
Tighten gun securing knob.
If the gun power pin does not
have a groove, loosen knob to ro-
tate the gun locking tab 180 de-
grees. This prevents the the gun
locking tab from interfering with
the gun power pin when inserted
into the gun block. Insert the gun
power pin into the gun block. Pos-
ition power pin as close as pos-
sible to drive rolls without touch-
ing them. Tighten gun securing
knob.
6
Gun Trigger Plug
7
Gun Trigger Receptacle
Connect gun trigger plug to gun
trigger receptacle.
See Section 6-3 to make wire
speed dual schedule connec-
tions to gun trigger receptacle.
8
Voltage Sensing Clamp
Connect voltage sensing clamp
to workpiece.
7
256617-A / 278800-A
OM-278792 Page 15