- ページ 8

浄水器 Aquasana AQ-UV-L330CのPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aquasana AQ-UV-L330C 20 ページ。 Whole house uv filter

INSTALLATION STEPS

Installation Checks and Options

1. To facilitate future lamp replacements, ensure there is enough space

at the UV Lamp connector end to safely remove the UV Lamp

and/or Quartz Sleeve.

NOTE: Leave at least an additional UV Reactor length to facilitate UV

Lamp and Sleeve removal.

2. The Controller will require a ground fault circuit interrupter (GFCI or GFI)

outlet and should be mounted beside or above the UV Reactor.

3. For water supplies where the maximum flow rate is unknown, a flow

restrictor is recommended so that the rated flow of your particular

Aquasana system is not exceeded. The flow restrictor should be

installed on the outlet port of the UV Reactor.

4. The UV Reactor can be installed

either horizontally or vertically

using the clamp provided.

Vertical installation is the preferred

method with the inlet at the bottom

(UV Lamp connection at the top)

as it allows any air that may be in

the lines to be easily purged

from the system.

Vertical

(preferred)

Horizontal