- ページ 27

ビデオカメラ Panasonic WV-SP305のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Panasonic WV-SP305 36 ページ。 Ip video cameras
Panasonic WV-SP305 にも：仕様 (2 ページ), 比較表 (6 ページ), 特徴と仕様 (2 ページ), 仕様 (2 ページ), 統合ノート (8 ページ)

ページを印刷する

When using 12 V DC power supply*

q Loosen the screw of the power cord plug (accessory).

w Connect the cable of the 12 V DC power supply* to the

power cord plug.

Strip 3 mm to 7 mm {1/8" to 9/32"} from the end of the

wire, and twist the stripped part of the wire sufficiently to

avoid short circuit.

Specification of cable (wire): 16 AWG - 24 AWG,

Single core, twisted

• Check whether the stripped part of the wire is not

exposed and is securely connected.

e Tighten the screw of the power cord plug.

r Connect the power cord plug to the 12 V DC power sup-

ply terminal on the rear of the camera.

* FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC

CLASS 2 POWER SUPPLY.

Important:

• Be sure to use the power cord plug provided with this product.

• Be sure to fully insert the power cord plug into the 12 V DC power supply terminal. Otherwise,

it may damage the camera or cause malfunction.

• When installing the camera, make sure that excessive force is not applied to the power cable.

• Be sure to use an AC adaptor compliant with the Specifications regarding power source and

power consumption (

When using PoE (IEEE802.3af compliant)

Connect a LAN cable (category 5 or better, straight, STP*) between a PoE device (such as a hub)

and the network connector of the camera.

* PAL models only.

Important:

• Use all 4 pairs (8 pins) of the LAN cable.

• The maximum cable length is 100 m {328'}.

• Make sure that the PoE device in use is compliant with IEEE802.3af standard.

• When connecting both the 12 V DC power supply and the PoE device for power supply, PoE

will be used for power supply.

• When disconnecting the LAN cable once, reconnect the cable after around 2 seconds. When

the cable is quickly connected, the power may not be supplied from the PoE device.

p.32).

☞

10BASE T/100BASE-TX

AUDIO OUT

MIC/LINE IN

ACT

LINK

SD CARD/ABF

MONITOR OUT

EXT I/O

GND 4 3 2 1

ALARM IN 1/DAY/NIGHT IN

AUX OUT

ALARM OUT

To 12 V DC

power supply*

(This illustration represents

WV-SP306.)

12 V DC power

cord plug

(accessory)

(GND)

INITIAL

SET

POWER

12V = IN

(12 V DC)