- ページ 8

リフティングシステム Aquatic Access IGAT-90のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Aquatic Access IGAT-90 18 ページ。 Pool lift

PREPARING TO INSTALL LIFT

To assemble the lift, you will need two adjustable wrenches to tighten the nuts and bolts

provided.

In most cases, the lift ships from our factory in two cartons. The long carton contains the cylinder

assembly, the wheelbase mounting plate, and the wheel assembly. The wheel assembly is

wrapped in bubble wrap and attached to the hose with a zip tie. In the other carton, you will find

the seat assembly, the socket, and any accessories you ordered with your lift.

Slide the mounting arm onto the inner telescope and attach T-support bracket using the bolt

and nut supplied with the T-foot support. Additional torque on this bolt will squeeze the walls

together on the outer mounting arm telescope to eliminate looseness with the inner telescope. The

T-support bracket attaches on the side of the cylinder opposite the valve.

To attach wheel assembly, detach the wheelbase mounting plate from bottom of cylinder by

removing the two bolts. Insert the same bolts through holes in wheel assembly, wheel base

mounting plate, and base of cylinder.

If your installation includes a vinyl-liner wall pad assembly, you will find it packed under the

seat assembly. Attach it to the ends of wheelbase mounting plate with the bolts and nuts supplied

with the vinyl-liner wall pad. When properly adjusted, the pad should be flush against the pool

wall with the cylinder vertical. Tighten bolts after adjustment.

Insert lift fully into socket and make sure the post's tab fits into the notch in the socket. Check

adjustment of wheelbase mounting plate (and vinyl-liner wall pad, if used), making sure that it

touches the pool wall firmly. Note: the wheelbase mounting plate can be rotated 180° to achieve

a better adjustment. Remove lift to adjust. Tighten bolts after satisfactory adjustment.

Failure to maintain a tight fit between the wheel base mounting plate (and vinyl-liner wall

pad, if used) against the pool wall can result in movement of the cylinder which may prevent

achievement of lifting capacities at advertised water pressures.

Re-insert lift into socket. Check for secure contact of wheelbase mounting assembly (and vinyl-

liner wall pad if used) against the pool wall and t-support bracket on deck when cylinder is

vertical.

Attach seat assembly to piston rod frame with the bolt provided. Adjust seat height by selecting

an appropriate hole on piston rod frame Tighten lock nut securely, making sure bolt has

penetrated nylon insert of lock nut. Two bolt threads should be visible past the nylon insert.