ページを印刷するUsage
4.5.2. Changing grinding tools
1.
Figure 4-5 Removing grinding tools
2.
3.
4.6. Preparations for dry grinding
Warning!
Check that the splash guard is fitted.
1.
20
Remove the grinding tool by giving it a few light taps
with a rubber hammer so the locking mechanism releases,
see Figure 4-5 on page 20. Then draw the tool up out of
the guide slot.
Slide the grinding tool diagonally, from above, down into
the appropriate guide slot on the tool holder, see Figure
4-3 on page 19. Then push the tool fully into the guide
slot.
Lock the grinding tool into the tool holder by giving
it a few light taps with a rubber hammer - see Figure
4-4 on page 19.
Connect a dust extractor to the machine. For dust extractor
models, see under the Suction System tab in the HTC
Product Catalogue.
HTC 500
1.0