- ページ 11

アンプ Axxera AX3000MのPDF インストレーション＆オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Axxera AX3000M 17 ページ。 Mobile power amplifiers
Axxera AX3000M にも：インストレーション＆オーナーズマニュアル (17 ページ)

ページを印刷する

INSTALLATION

Connecting Two Amplifiers - Bridge Mode

Master/Slave Mode (cont.)

*MASTER

For master ampliﬁer, set the switch to master. This will route the signal through Line-out to

the slave ampliﬁer. Set the phase to 0, all adjustments for gain and sound are done on this

ampliﬁer. The remote subwoofer control should be connected to master ampliﬁer as well.

*SLAVE

For slave ampliﬁer, set the switch to slave and phase to 180. Connect the Line-out of master

ampliﬁer to input on this ampliﬁer. All adjustments should be set to minimum.

Connect Data-Link plug from master to slave ampliﬁer. For speaker connection, the positive

(+) of the speaker connects to positive (+) of master and negative (-) of the speaker connects to

positive (+) of slave ampliﬁer. Connect both negatives (-) of master and slave each other.

NOTE: FOR BEST PERFORMANCE, USE WIRE 12 AWG OR THICKER FOR THE NEGATIVE TO

NEGATIVE CONNECTION.

*MINIMUM IMPEDANCE MUST NOT BE LOWER THAN 2 OHMS