- ページ 11
溶接システム ARCCAPTAIN CUT50のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。ARCCAPTAIN CUT50 20 ページ。 Plasma cutter 50a
ページを印刷する3. INSTALLATION AND CONNECTION
3.1 Installation requirements
1) Connection of input cable
In order to ensure personal safety and avoid electric shock, please send the product
power plug the grounding and wiring box grounding device,reliable grounding protection.
A primary power supply cable is available for this cutting machine. Connect the power
supply cable to the rated input power. The primary cable should be tightly connected to
the correct socket to avoid oxidization. Check whether the voltage value varies in
acceptable range with a multi-meter.
The cross section of the leads used in the switching box should meet the requirements of
the maximum input capacity of the machine.
2) Connection of output cable
Line disconnecting switch
Install a line disconnecting switch at each power
supply, so that the power supply can be cut off
immediately
in
case
disconnecting value of the switch should be equal to or
greater than the continuous rating of the fuse. In
addition, the switch should have the following feature:
·The power is cut off when the switch is at "OFF"
position.
Connection of cutting torch
Connect the center plug on the cutting torch to the
center socket of the power supply, and tighten It
clockwise to avoid gas leakage.
Connection of earth cable
Insert the quick plug on the earth cable into the output
terminal "+" on the front panel of the machine, and
tighten it clockwise.
Digital Welder Expert, Know You More
of
an
emergency.
8
The
Pic 4
Pic 5
Pic 6
https://www.arccaptain.com