- ページ 25

スイッチ Cisco ASR 920 seriesのPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ASR 920 series 42 ページ。 Aggregation services router
Cisco ASR 920 series にも：設置マニュアル (36 ページ), はじめに (6 ページ), ハードウェア・インストール・マニュアル (46 ページ), マニュアル (36 ページ)

Installing the Cisco ASR 920 Series Router

Do not remove the rubber plugs from the SFP module port or the rubber caps from the fiber-optic cable

Caution

until you are ready to connect the cable. The plugs and caps protect the SFP module ports and cables from

contamination and ambient light.

SUMMARY STEPS

1. Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.

2. Insert one end of the fiber-optic cable into the SFP module port.

3. Insert the other cable end into a fiber-optic connector on a target device.

4. Observe the port status LED.

5. If necessary, reconfigure and restart the router or target device.

DETAILED STEPS

Step 1

Remove the rubber plugs from the module port and fiber-optic cable, and store them for future use.

Step 2

Insert one end of the fiber-optic cable into the SFP module port.

Step 3

Insert the other cable end into a fiber-optic connector on a target device.

Step 4

Observe the port status LED.

The LED turns green when the router and the target device have an established link.

If the LED is off, the target device might not be turned on, there might be a cable problem, or there might be problem

with the adapter installed in the target device.

Step 5

If necessary, reconfigure and restart the router or target device.

Install the Chassis Ground Connection

Before you connect the power or turn on the power to the router, you must provide an adequate chassis ground

(earth) connection to your router.

This section describes how to ground the router chassis. The grounding lug location is on the back panel of

the router.

Cisco ASR 920 Series Aggregation Services Router Hardware Installation Guide

Install the Chassis Ground Connection