- ページ 7

コントローラー AccuStream Abrasive Regulator IIのPDF マニュアルをオンラインで閲覧またはダウンロードできます。AccuStream Abrasive Regulator II 10 ページ。

AccuStream Cutting Systems

If the abrasive flow does not stabilize due to air bubbles in the hose and puffing at the top of the

regulator:

Make sure that the pot is full of abrasive. Low abrasive content will allow air to push through

•

the abrasive and cause a bubbling effect in the abrasive delivery hose.

Make sure there is at least the minimum of abrasive feed elevation going into the top of the

•

regulator and that there is a ½" elbow on the top inlet of the regulator.

Check to see if the abrasive has clumped inside the pot. Clumped abrasive will let air pass

•

through the abrasive. Discharge the contents of the pot into clean containers. Pour the emptied

dry abrasive through a window screen and back into the pot.

If there is moisture in the abrasive, it should be discarded. Verify that the air pressure regulator

•

bowl on the pot is emptied of water.

Moisture or Water

When the nozzle is plugged, water will go up the feed hose to the

regulator and discharge from the vent hole on the back of the

Output Adapter. If this occurs, the Adapter will need to be

cleared.

With the jet ON and the Regulator OFF, plug the back VENT

hole (right). This should vacuum any moisture and abrasive from

the Adapter.

If the abrasive still does not flow:

1. Disconnect the regulator hose from the cutting

head.

2. Loosen the 2 (two) thumbnuts that connect the

Regulator Base to the regulator.

3. Lower and turn the base (Right).

4. Hold the open end of the hose over the tank and

blow the contents of the regulator base into the

tank until regulator base bowl and hose are dry.

5. Reconnect the regulator base and hose.

Any moisture reaching the regulator, from piercing should

be minimized. It is best to use a splashguard on the

nozzle.

13096 Abrasive Regulator II Manual

THUMBNUTS

RREGULATOR

BASE