ページを印刷するE9
TROUBLESHOOTING
The following problems do not always indicate a hardware failure. Therefore, please use the
troubleshooting guide below before calling for repair service.
If, after following the guide none of the remedies work, unplug the TV set and call for service.
Quick Service Check List
Possible Causes/Remedies
Try a new channel to check for possible station trouble.
TV not plugged in. Outlet power OFF.
POWER switch of TV not ON.
Antenna not connected to terminal at the back of the TV set.
If outside antenna is used, check for broken wires.
Check for local interference.
Turn OFF using the
POWER switch, then turn ON again after a minute.
Adjust COLOUR control.
Check batteries in the remote control.
Try fine tuning to correct.
Contrast setting in picture mode might be all the way to the minus side.
Press the NORMAL button on the remote control to correct.
Increase the volume.
This unit is equipped with a microprocessor. Its performance could be adversely affected by external electrical
noise or interference. If this should happen, unplug the unit and plug it in again after a few minutes.
E10
SPECIFICATIONS
MODEL
14T1-U
Receiving System
World multi 18 system
PAL – B/G, I, D/K
Receiving Frequency
48.25 MHz – 863.25 MHz
Channel Tuning
100-Channel Electronic Tuner with Full Auto Tuning System
Terminals
Audio/video input × 2 (front x 1, rear x 1), Audio/video output × 1 (rear),
Headphone jack x 1 (front)
Sound Output
3 W (RMS) × 1
Power Source
AC 110 – 240V, 50 Hz / 60 Hz
Power Consumption
62 W
Dimensions
352 (W) × 334 (H) × 355 (D) mm
Weight
8.8 kg (Approx.)
• Design and specifi cations are subject to change without notice.
• Receiving system: These receiving systems, encompassing all currently available technology, include those with planned
broadcast, videotape and laserdisc hardware and software.
14T1-U_EN.indd 4
14T1-U_EN.indd 4
SECAM – B/G, D/K, K1
NTSC 4.43 – B/G, I, D/K
SHARP CORPORATION
10/25/07 11:42:27 AM
10/25/07 11:42:27 AM