- ページ 39

プロジェクター Sharp Notevision PG-M10SのPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Sharp Notevision PG-M10S 49 ページ。 Digital multimedia projector
Sharp Notevision PG-M10S にも：操作マニュアル (49 ページ), 基本情報と準備 (10 ページ)

ページを印刷する

Replacing the Projection Lamp

CAUTION:

• Potential hazard of glass particles if lamp has ruptured. Please have Sharp Authorized LCD Projector Dealer or

Service Center replace lamp if rupture occurs.

• Do not remove the lamp cage directly after operation of the projector. The lamp may be extremely hot. Wait at

least one hour after the power cord is disconnected to allow the surface of the lamp cage to fully cool before

removing the lamp cage.

The rated lamp life is about 1000 hours. The rated lamp life is the average life of the lamps produced and tested (under the

test conditions of our company). However, it may become shorter depending on the conditions of usage.

After the lamp has been operating for 1000 hours or longer, the STATUS indicator on the control panel will light and the "LAMP

USAGE" icon which shows hours of total lamp usage will be displayed on the screen. When this happens, turn off the unit and

replace the lamp cage with a new one. The unit will not turn on after 1100 hours. (It will go off if it is in use.)

Removing and installing the lamp unit

CAUTION

• Be sure to remove the lamp cage by the handle. Be sure not to touch the glass surface of the lamp cage or the inside of the projector.

• Do not loosen any screws except for those mentioned in the instructions below. There is danger of electric shock.

• To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps below.

Turn off the power.

Press the POWER ON/OFF button.

Wait until the cooling fan stops.

10 X

PG -M

MOUSE

ON/OFF

VIDEO

COMPUTER

R-CLICK/EXIT

DIGITAL MULTIMEDIA

PROJECTOR

Remove the lamp

cage.

Unfasten the three securing

screws on the lamp cage. Hold

the lamp cage by the handle and

pull it upward.

• Reset the lamp usage timer after replacing the lamp. See page 29 for information.

• When the lamp usage timer reaches 1100 hours, it becomes impossible to turn on the power and menus are not displayed. In such a case,

see "When the lamp usage timer has exceeds 1100 hours and the unit will not turn on" on page 29.

• Obtain a replacement lamp cage at the store where the unit was purchased. Please specify the following information when ordering a

replacement lamp cartridge:

– Model name : BQC-PGM10X//-1

Disconnect the power

cord.

Unplug the power cord from the

AC socket. Wait at least one hour

after power cord is disconnected.

ON/OFF

Replace the lamp cage

(after changing the lamp).

Press the lamp cage firmly into

the lamp cage compartment.

Fasten the securing screws.

Securing

screws

Open the lamp cage

cover.

Turn over the projector and un-

fasten the user service screw that

secures the lamp cage cover.

Then open the cover in the direc-

tion of the arrow.

User service screw

Close the lamp cage

cover.

Close the lamp cage cover in the

direction of the arrow. Then

fasten the user service screw.

User service

screw