- ページ 14
自転車アクセサリー Shimano BB-RS500のPDF ディーラーズマニュアルをオンラインで閲覧またはダウンロードできます。Shimano BB-RS500 20 ページ。 Crankset
ページを印刷するINSTALLATION
Installing the crank arms
(B)
3
(A)
(z)
4
(B)
(C)
(C)
(A)
Use the SHIMANO original tool to
tighten the cap.
Push in the stopper plate and check that
the plate pin is securely in place, and
then tighten the screws of the left crank
arm.
Tighten both screws equally to the
specified tightening torque (12 - 14 N·m).
(z)
The illustration is of the left crank
arm (cross-section)
14
(A)
TL-FC16
(B)
Cap
(C)
Apply grease:
Premium Grease
(Y04110000)
Tightening torque
0.7 - 1.5 N·m
(A)
Plate pin
(B)
Stopper plate
(C)
Left crank arm
Tightening torque
12 - 14 N·m
NOTICE
•
The two screws should be tightened
alternately in stages rather than each screw
being fully tightened at once.
•
Set the stopper plate in the correct
direction as shown in illustration.