- ページ 9

アクセサリー Bitspower Touchaqua BPTA-WDP303CのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Bitspower Touchaqua BPTA-WDP303C 15 ページ。

ページを印刷する

Hard tube bending guide（Accessories not included）

Hard tube

Silicon strip

Remark:This step is a guideline for

beginners. With experience, you will

develop your own style of bending tubes,

Water

Choose your desired dye color and mix it with pure distilled water. Pour the water mix into the reservoir via the water filling hole. Once the reservoir is

90% full, turn on the power supply for the pump to run and let the air exit the loop. Turn off the power supply when the reservoir is near empty. Repeat

until all the air has exited the loop. (In order to power the pump only, connect the power switch connector to the 24 pin cable of the power supply. This

will allow the power supply to bypass the motherboard and make the pump work alone.)

Notice:Bitspower recommends that consumers add the Bitspower dye to

distilled water or purified water for their water-cooling liquid. If the

consumer chooses different water-cooling liquids, the resulting impu-

rities may cause peeling of the coating on some of the hardware, water

channels blockage by built-up residue, improper operation of the water

pump, water tank tube breakage, and o-rings deformation leading to

leakage. Any issues related to the use of inappropriate water-cooling

liquid will be the responsibility of the consumer.

Do not turn on the pump if the reservoir is empty.

---Product Warranty Rules---

The warranty will be void if any of the situations below

happen.

【CPU Water Block】

- The CPU block and the screws in it has any trace of disassemble.

- The top plate inlet and outlet ports, due to improper use of

external forces, are cracked.

【Radiator】

- The fin of the radiator are broken or deformed due to improper

use of external forces.

- The inlet and outlet of the radiator are cracked due to improper

use of external forces.

【Fitting】

- There are signs of damage caused by instrument clamping on the

fittings.

【PUMP】

- Pump damage from pump operation without any liquid.

- Pump damage caused by water leak on the pump's PCB.

- Water tank has been separated from the pump.

【Fan】

- Fan damaged by water leak.

1. Insert the silicon strip (sold separately) inside

the hard tube.

2. Heat up evenly the area where the hard tube

needs to be bent (We suggestyou use a heat

gun for this step).

3. During the process of heating, please turn

the hard tube to heat evenly.

4. Once the tube is hot enough to bend easily,

move it to the bending tool andbend at the

desired angle.

5. We recommend using the Bitspower bending

kit (BP-PTR12/BP-PTR14/BP-PTR16).

P 4

Hard tube fitting installation guide

Hard tube installation steps:

1.First screw the fitting clockwise into the

G1/4" hole.

2.Slide the sleeve on the tube, then push the

OPEN

tube into the nut over the o-ring

3.Lock the nut tightly to the sleeve using a

clockwise rotation.

OPEN

Water filling hole