- ページ 32

プリンター Ricoh Pro C7100sxのPDF スターターマニュアルをオンラインで閲覧またはダウンロードできます。Ricoh Pro C7100sx 40 ページ。
Ricoh Pro C7100sx にも：最初に読むマニュアル (40 ページ)

3. Other Information for This Machine

Laser Safety for Type 2 and 4

This machine complies with the requirements of IEC60825-1:2007 (EN60825-1:2007) for class 1

laser product. The machine contains five VCSELs (Vertical Cavity Surface Emitting Laser), 772–792

nanometer wavelength. The beam divergence angle is 5.5 degrees (minimum) and 7.9 degrees

(maximum) in the vertical direction, and 5.5 degrees (minimum) and 7.9 degrees (maximum) in the

horizontal direction, and laser beams are generated in Continuous Wave (CW) mode. The VCSEL has

forty light sources and the maximum output power of each light source is 1.23 milliwatt.

The following label is attached on the rear of the machine.

Caution

Use of controls or adjustments or performance of procedures other than those specified in this manual

might result in hazardous radiation exposure.

Laser Safety for Media Identification Unit Type S3

Media Identification Unit (optional) complies with the requirements of IEC60825-1:2007

(EN60825-1:2007) for class 1 laser product. Media Identification Unit contains one VCSEL (Vertical

Cavity Surface Emitting Laser), 772–792 nanometer wavelength. The beam divergence angle is 5.3

degrees (minimum) and 7.9 degrees (maximum) in the vertical direction, and 5.3 degrees (minimum)

and 7.9 degrees (maximum) in the horizontal direction, and laser beams are generated in Continuous

Wave (CW) mode. The VCSEL has twelve light sources and the maximum total output power is 2.5

milliwatt.

The following label is attached on the bottom of the machine.

Caution

Use of controls or adjustments or performance of procedures other than those specified in this manual

might result in hazardous radiation exposure.