Configuring the Router
•
•
•
•
•
•
Power Up Procedure
To power up your Cisco router and verify that it goes through its initialization and self-test, follow the
procedure below. When the procedure is finished, the Cisco router is ready to configure.
If you encounter problems when you power on the router, refer to the
Routers
For information about the ROM monitor and the bootstrap program, refer to the
document. For information about the configuration register, refer to the
Configuration Guide
To view the boot sequence, you must have a console connection to the Cisco router before it powers up.
Note
Make sure that your PC is powered up and connected as described in the
Step 1
section on page
Move the power switch to the ON position.
Step 2
The following indications appear:
•
•
Depending on your installation, some LEDs on the rear of the chassis and on installed modules might
also come on.
If you encounter problems when you power up the router, refer to the
Routers
Startup messages appear in your terminal emulation program window. When the startup messages end,
the SYS PWR LED comes on solid green.
Do not press any keys on the keyboard until the messages stop and the SYS PWR LED is solid green. Any
Caution
keys pressed during this time are interpreted as the first command typed when the messages stop, which
might cause the router to power off and start over. It takes a few minutes for the messages to stop.
Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers
10
The external CompactFlash memory card is properly seated into its slot. For installation
instructions, see the online document
Cisco 2800 Series
Routers.
PC with terminal emulation program (hyperTerminal or equivalent) is connected to the console port
and powered up.
Your PC terminal emulation program is configured for 9600 baud, 8 data bits, 1 stop bit, no parity,
and flow control is set to "none."
Suitable PC COM port is selected in the terminal emulation program.
You have selected passwords for access control.
You have determined the IP addresses for the Ethernet and serial interfaces.
online document.
document.
1.
The SYS PWR LED on the front of the chassis blinks green.
The fans operate.
online document.
Removing and Installing CompactFlash Memory Cards in
Troubleshooting Cisco 2800 Series
Troubleshooting Cisco 2800 Series
Using the ROM Monitor
Cisco 2800 Series Software
"Checklist for Power Up"
OL-5788-01
ページを印刷する