- ページ 9

ネットワーク・ルーター Cisco 2950 - Catalyst SwitchのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2950 - Catalyst Switch 19 ページ。 Long-reach ethernet switches
Cisco 2950 - Catalyst Switch にも：解決マニュアル (17 ページ), 製品情報 (3 ページ), 製品サポート速報 (5 ページ), 移行マニュアル (25 ページ), 製品サポート速報 (6 ページ), スタートマニュアル (29 ページ), データシート (20 ページ)

Cisco - Connecting a Terminal to the Console Port on Catalyst Switches

Switch Console (DCE)

2 Rxd

3 Txd

4 RTS

5 CTS

6 DSR

7 GND

8 DCD

20 DTR

Configuring a Terminal for Attachment to the Console Port

Note: The console port is an asynchronous serial port; any device connected to this port must be capable

of asynchronous transmission.

Before connecting the console port, check the terminal documentation to determine the baud rate. The

baud rate of the terminal must match the default baud rate (9600 baud) of the console port. Set up the

terminal as follows:

9600 baud

8 data bits

No parity

1 stop bit

Connecting a Terminal to the Catalyst 5000

Supervisor Engine III Console Port

The port is located on the Supervisor Engine front panel and is labeled "CONSOLE," as shown above.

The port is an EIA/TIA-232 asynchronous, serial, full-featured data terminal equipment (DTE)

connection with hardware flow control and an RJ-45 connector. Use a straight-through cable to connect

the switch to a Data Terminal Equipment (DTE) device, such as a terminal or PC.

Note: If you need a replacement console port accessory kit for your Supervisor Engine III, the part

http://www.cisco.com/warp/public/473/9.html (9 of 19) [9/4/2003 12:36:03 PM]

Terminal (DTE)

3 TxD

2 RxD

7 RTS

8 CTS

6 DSR

5 GND

1 DCD

4 DTR