- ページ 14

無線アクセスポイント Cisco AIR-AP1141N-E-K9のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco AIR-AP1141N-E-K9 37 ページ。 Autonomous access point

You can restore the access point to its factory defaults by unplugging the power jack and

Note

plugging it back in while holding the Mode button down until the Ethernet LED turns amber

(approximately 2 to 3 seconds).

Enabling the Radio Interfaces

The access point radios are disabled by default, and there is no default SSID. You must create an SSID

and enable the radios before the access point allows wireless associations from other devices. Refer to

the "Configuring Basic Security Settings" section on page 15 for instructions on configuring the SSID.

Follow these steps to enable the radio interfaces:

Browse to your access point.

Step 1

When the Summary Status page appears, click 802.11N

Step 2

appears.

Choose the Settings tab at the top of the page. The Radio Settings page appears.

Step 3

Click Enable in the Enable Radio field.

Step 4

Click Apply.

Step 5

Return to the Summary Status page and click 802.11N

Step 6

appears.

Repeat Steps 3-5.

Step 7

Close your web browser.

Step 8

After you assign basic settings to your access point, you must configure security settings to prevent

unauthorized access to your network. Because it is a radio device, the access point can communicate

beyond the physical boundaries of your work site.

Just as you use the Express Setup page to assign basic settings, you can use the Express Security page

to create unique SSIDs and assign one of four security types to them. For detailed security information,

refer to the Cisco IOS Software Configuration Guide for Cisco Aironet Access Points.

2.4GHz

. The 2.4-GHz radio status page

5GHz

. The 5-GHz radio status page