- ページ 24

無線アクセスポイント Cisco AIR-LAP1310GのPDF 取付方法をオンラインで閲覧またはダウンロードできます。Cisco AIR-LAP1310G 40 ページ。 Cisco aironet 1300 series lightweight outdoor access point

Mounting the Access Point

Caution

Note

Cut the cables to length, install F-connectors on the ends, and connect them to the grounding block.

Step 5

Weather seal all coaxial connectors by wrapping them with the sealant tape provided with the installation

Step 6

kit. For more information, see the

Applying Coax Seal Tape

You must weather seal all coaxial connections using the Coax-Seal tape provided in the mounting kit.

Coax connections that are not properly sealed permit moisture to enter the connection, which leads to

performance degradation or link problems.

The following connectors must be weather sealed:

•

Do not use only plastic electrical tape on the connectors because it deteriorates during long-term

Note

exposure to ultraviolet light and extreme weather.

To apply Coax Seal, follow these steps:

Make sure that the coaxial cables, connectors, and the connector area are clean and dry.

Step 1

Peel the paper backing from a 10-inch length of Coax-Seal tape.

Step 2

Wrap each access point connector with the tape, starting at the coaxial cable, extending across the

Step 3

connector body, and finishing close the access point or grounding block. Overlap each turn at least 50

percent so there is a double thickness over all areas (see

Note

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

To prevent damage to the access point or power injector, connect all coax cables from the

power injector to the access point and connect the power jack to the power injector before

applying power.

The grounding block must be connected to the building's grounding system by # 14 AWG copper

wire or larger.

F-connectors, located at the access point and each grounding block.

R-TNC antenna connectors, when using the access point with an external antenna.

To simplify removal of the connector in the future, you can first wrap the connector with a good

grade of electrical tape before applying the Coax-Seal. You should tightly wrap the electrical

tape and overlap each turn at least 25 percent for full coverage.

"Applying Coax Seal Tape" section on page

Figure

24.

8).

78-17634-01