- ページ 7

ウェザーステーション ACU-RITE 00875のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ACU-RITE 00875 16 ページ。 Digital rain gauge with wireless self-emptying rain collector

Rain Collector Installation

• To ensure accurate rain measurement, the rain collector MUST be placed on

a flat, level surface.

• Ensure the rain collector is not placed in a low spot that could become

flooded or in an area where there are obstructions above it.

DO NOT

1. Separate the rain collector cover from the rain collector base.

PLACE IN WATER OR

IN UNEVEN OR LOW

2. Locate the two holes on the rain collector base.

SPOTS THAT MAY

3. Fasten the rain collector base to a sturdy surface, like a deck railing or a

BECOME FLOODED.

fence post, with screws (included) using hand tools. (Power tools may slip

during installation, causing damage to the rain collector.)

Setup is Complete

The rain collector will now synchronize with the display unit. It may take a few

minutes for synchronization to complete. Please refer to the troubleshooting

section of this manual if anything appears to be functioning improperly.

(.9 m)

DO NOT

PLACE IN AREAS WHERE

PLANT GROWTH CAN

GROW INTO CASE AND

OBSTRUCT RAIN FLOW

THROUGH COLLECTOR

SQUEEZE

SQUEEZE TABS TO OPEN

165 feet maximum

(50 meters)

DO NOT

PLACE IN AN

AREA WITH

OBSTRUCTIONS ABOVE

INSTALL 2 SCREWS USING

HAND TOOLS ONLY.

THEN RE-ATTACH UPPER CASING

PLACE ON A LEVEL

SURFACE AT LEAST

3 FEET FROM THE

GROUND WITH NO

OBSTRUCTIONS ABOVE.