- ページ 19

無線アクセスポイント Cisco NCS 4201のPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco NCS 4201 42 ページ。

Installing the Cisco NCS 4201

Caution

Do not use the captive installation screw to pull out the power supply.

Step 6

Grasping the power supply handle with one hand, pull the power supply out from the chassis while supporting it with

the other hand.

Step 7

Replace the DC power supply within 5 minutes. See figure Installing a DC Power Supply. If the power supply bay is to

remain empty, install a blank filler plate (Cisco part number 800-39165-01) over the opening, and secure it with captive

installation screws.

Installing an AC power Supply

The following sections describe how to install an AC power supply in the Cisco NCS 4201:

This product requires short-circuit (over current) protection, to be provided as part of the building

Warning

installation. Install only in accordance with national and local wiring regulations. Statement 1045

Installing an AC Power Supply Module

Note

Open and remove the door before performing this procedure. See

Installing an AC power Supply

Removing the Front Door

Cisco NCS 4201 Hardware Installation Guide

section.