- ページ 31

無線アクセスポイント Cisco NCS 4201のPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco NCS 4201 42 ページ。

Installing the Cisco NCS 4201

Perform the following procedure to ground the Cisco NCS 4201 using a 2-hole lug and the corresponding

mounting point. Most carriers require a minimum 6-AWG ground connection. Verify your carrier's requirements

for the ground connection.

Step 1

If your ground wire is insulated, use a wire-stripping tool to strip the ground wire to 0.5 inch ± 0.02 inch (12.7 mm ±0.5

mm) (the figure below).

Figure 24: Stripping a Ground Wire

Step 2

Slide the open end of your 2-hole ground lug over the exposed area of the ground wire.

Step 3

Using a crimping tool (as specified by the ground lug manufacturer), crimp the ground lug to the ground wire as shown

in figure below.

Figure 25: Crimping a Ground Lug on to the Ground Wire

Step 4

Use a Phillips head screwdriver to attach the 2-hole ground lug and wire assembly to the chassis with the 2 pan-head

Phillips head screws.

Step 5

Connect the other end of the ground wire to a suitable grounding point at your site.

Installing the Chassis Ground Connection

Cisco NCS 4201 Hardware Installation Guide